Redmine

02/03/2026

SN 12:03 PM Gateway 3.0 Task #3337 (Resolved): TV2.1 Hardware Readiness

I removed the GPS module from the V2P1 tracker board and placed a UART to RS232 module in the same place, then connected the circuit. I also checked and verified the RS232 to UART connector connection at the external connector. Surendra Naik

SN 12:03 PM Gateway 3.0 2:00 hours (Task #3337 (Resolved): TV2.1 Hardware Readiness)

rs232 module placement Surendra Naik

SN 09:28 AM Gateway 3.0 Task #3337 (In Progress): TV2.1 Hardware Readiness

Surendra Naik

26/02/2026

SN 12:24 PM mDAQ4-1(Mid Range mDAQ)-Pilot 8:00 hours (Task #3261 (In Progress): RTU Cable for DI, DO, AI)

cable assembly for RTU Surendra Naik

SN 12:24 PM mDAQ4-1(Mid Range mDAQ)-Pilot Task #3261: RTU Cable for DI, DO, AI

For the RTU cable (DI, DO, AI), I prepared 1-meter length wiring with a D-sub connector.
Now testing is pending. Surendra Naik

19/02/2026

SN 08:03 AM mTracker(Mid Range GW)-Pilot 4:00 hours (Task #2979 (In Progress): Hardware Readiness)

GW mcu board testing & rework Surendra Naik

SN 08:03 AM mTracker(Mid Range GW)-Pilot Task #2979: Hardware Readiness

3 set boards that came from the assembly house, I completed rework and mounted the DNP components and TH connectors on the 1set MCU, 4G, and Wi-Fi boards. Surendra Naik

18/02/2026

SN 12:07 PM mDAQ4-1(Mid Range mDAQ)-Pilot 2:00 hours (Task #3159 (Resolved): PLCIO Interface Cable)

PLCIO Interface Cable Surendra Naik

SN 12:07 PM mDAQ4-1(Mid Range mDAQ)-Pilot Task #3159 (Resolved): PLCIO Interface Cable

PLCIO Interface Cable PREPARATION COMPLTED Surendra Naik

22/01/2026

SN 12:56 PM mTracker(Mid Range GW)-Pilot Task #2973: Mechanical Assembly

I assembled the LED PCB and fixed it to the top enclosure; the wiring is also good. I fully closed two sets of enclosures with the LED PCB and USB cable and handed them over to Devi Priya for software testing. Surendra Naik