TPMS 2-Wheeler

Schematic Design -
PCB Design -

https://elpisit-my.sharepoint.com/:f:/g/personal/satish_sl_elpisitsolutions_com/IgA-1KXsv-yQTKzvJ0082ykuARtxgUqxL1wxKkjqGEtS3dc?e=cbipmn

PCB power has sent 3 queries and Bhavani is working on it

1. Need to increase 0.16mm top side and decrease 0.16mm bottom
2. With 30 mils trace route VCC vias in power layer
3. Delete VCC(3.3v) plane and add gnd plane in vcc layer
4. Place decoupling cap as per the power in to the IC
5. Decrease solder mask length from 1.5 to 1.2mm
6. Added a pull down resistor

1.As per the given inputs (mentioned above by Bhavani)updated the PCB of 2 wheeler.
2. Panel updated with the updated board file
3. Gerber Created and shared to Sumanth for reviewing.