SAM E54 Platform » mDAQ4-1(Mid Range mDAQ)-Pilot

Queries to customer emailed on 02/01/2026

Core4 Assumptions/Clarifications

1. Power supply is 24VDC and is available from panel. Device power consumption is max 10W
2. Sensors/controls are powered from panel power supply
3. Device is flange mounted
4. RS232 serial interface is considered as a connectivity to 4G modem.
   As the 4G modem is integrated within the device, RS232 signals will not be available externally.
   if needed, pls clarify with application details
5. 4G modems will have external antennas.
6. Two serial interfaces are available externally - RS-485 in Half Duplex mode
   This interface supports modbus RTU. will both the interfaces run parallely, what will be the application.
7. Digital Input(DI) will be 24vDC.
8. Analog input (A1) will support 4-20ma interface. sensor power should be part of the panel.
9. Device will acquire data every 1minute and send the same to Cloud (E-Remos)
10. Cloud Application, E-Remos needs to be configured per site the Analog input (sensor range)
11. E-Remos will allow modbus registers to be configured, is there more than 1 modbus device

Refer email from Vinay in response to queries

From: Vinay.K Vinay.k@elpisitsolutions.com
Sent: Tuesday, January 6, 2026 7:58 PM
To: Venu venu@elpisitsolutions.com
Subject: Re: Core4 mTracker and mDAQ Assumptions and clarifications

CRS => https://elpisit-my.sharepoint.com/:w:/g/personal/satish_sl_elpisitsolutions_com/IQDJmgwBU5fFQKtKTTftwqiWAU8IGIqwu014ymsKoftXtrY?e=LnAfCv

23/01/2026
Additional queries

1. What is the electrical layout of sensors(Analog input and Digital Input) and actuators (Digital Output) at each installation site ? This is to understand the distribution of mTracker and RTU at each site.
2. Provide the Sensor/actuator part no. and datasheet to understand the range and mapping requirements
3. What is the electrical layout of the panel in which mTracker and/or RTU units are installed. This is to understand the cable length required for the D-Sub25 Connector for RTU
4. It is recommended to use 0/4-20mA based sensors (instead of 0-10V) in the case of long cable run
5. The RTU is provided with 6 Digital outputs. What is the condition at which these are activated through the web based GUI application (E-REMOS) ?

Updated CRS => https://elpisit-my.sharepoint.com/:w:/g/personal/satish_sl_elpisitsolutions_com/IQBvIiIoSwpCRb4LehaHB053Adv8KCdBSnYU5_Fr5POkS-s?e=v6LHex

CRS document

https://elpisit-my.sharepoint.com/personal/satish_sl_elpisitsolutions_com/Documents/Elpis%20Projects%20Folder/Core4%20Energy/Customer%20Requirement